Q:
A successive A/D converter is
belongs to collection: COMPUTER ARCHITECTURE- BASIC COMPUTER ORGANIZATION MCQ
COMPUTER ARCHITECTURE- BASIC COMPUTER ORGANIZATION MCQ
- The main virtue for using single Bus structure is
- ______ are used to over come the difference in data transfer speeds of various devices
- To extend the connectivity of the processor bus we use ______
- IBM developed a bus standard for their line of computers ‘PC AT’ called _____
- The bus used to connect the monitor to the CPU is ______
- ANSI stands for
- _____ register Connected to the Processor bus is a single-way transfer capable
- In multiple Bus organisation, the registers are collectively placed and referred as ______
- The main advantage of multiple bus organisation over single bus is
- The ISA standard Buses are used to connect
- Which of the following is not a form of memory ?
- Which memory is difficult to interface with processor ?
- Desirable characteristic(s) of a memory system is(are)
- The minimum time delay required between initiation of two successive memory operations is called
- For a memory system, the cycle time is
- Generally , the refreshing rate of dynamic RAMs is approximately once in
- In comparison with static RAM memory, the dynamic RAM memory has
- Disadvantage of dynamic RAM over static RAM is
- Memory consisting of electronic circuits attached into silicon chip is known as
- Which of the following is the internal memory of the system (computer) ?
- The idea of cache memory is based on
- What is the correct sequence of time delays that happen during a data transfer from a disk to memory?
- If a system is 64 bit machine , then the length of each word will be ____
- The type of memory assignment used in Intel processors is _____
- When using the Big Endian assignment to store a number, the sign bit of the number is stored in _____
- To get the physical address from the logical address generated by CPU we use ____
- _____ method is used to map logical addresses of variable length onto physical memory
- During transfer of data between the processor and memory we use ______
- Physical memory is divided into sets of finite size called as ______
- Which is true for a typical RISC architecture?
- SIMD represents an organization that ______________
- Suppose that a bus has 16 data lines and requires 4 cycles of 250 nsecs each to transfer data. The bandwidth of this bus would be 2 Megabytes/sec. If the cycle time of the bus was reduced to 125 nsecs and the number of cycles required for transfer stayed the same what would the bandwidth of the bus?
- Von Neumann architecture is
- A Stack-organised Computer uses instruction of
- An n-bit microprocessor has
- PSW is saved in stack when there is a
- _________ register keeps tracks of the instructions stored in program stored in memory
- ‘Aging registers’ are
- Translation from symbolic program into Binary is done in
- MIMD stands for
- A k-bit field can specify any one of
- The time interval between adjacent bits is called the
- The communication between the components in a microcomputer takes place via the address and
- Data input command is just the opposite of a
- A binary digit is called a
- An interface that provides a method for transferring binary information between internal storage and external devices is called
- An address in main memory is called
- The information available in a state table may be represented graphically in a
- An interface that provides I/O transfer of data directly to and form the memory unit and peripheral is termed as
- A register capable of shifting its binary information either to the right or the left is called a
- Which of the following is a main memory?
- The maximum addressing capacity of a micro processor which uses 16 bit database & 32 bit address base is
- A successive A/D converter is
- A stack organized computer has
- A Program Counter contains a number 825 and address part of the instruction contains the number 24. The effective address in the relative address mode, when an instruction is read from the memory is
- A system program that translates and executes an instruction simultaneously is
- The memory location’s address where data is to be stored is specified by ___________
- The number of instructions being executed defines the
- Energy equation of pulse of the logic transition, can be computed as
- Software compatibility levels determines
- The no of good dies/wafer are called
- 3.3 GHz Core i7 running in short bursts for
- 80% cost of a $90M warehouse is associated with,
- The no of dies/300 mm or (30 cm)wafer for die which is 1.5 cm on a side and for that die which is 1.0 cm on a side, would be
- For comparing the performance of new system, the users will simply compare execution time of its
- With respect to changing among the states of accomplishment and interruption, a measure of continuous service-accomplishment, is known as
- Sustained power consumption; the given metric is widely known as
- Databases and transaction processing support; reliability and availability enhancements are provided by
- Static power being directly proportional to no of devices, that is known as
- 15% reduction in voltage results in a 15% frequency reduction, the impact on the dynamic energy and the dynamic power, is
- The most common and simple definition of time is called
- Every easily made mistakes and flaws in the computer design and architecture, are referred to as
- The sound output has data-rate of approximately
- 1000 disks having 1,000,000-hour MTTF, if failed disks are being replaced with a new one, having the same as all having reliability characteristics, the number of disks that would be failed in a year (8760 hours) is
- Dies which are 1.5cm on a side and 1.0cm on a side, supposing a density of 0.031/per cm^2 and N is 13.5, will have die yielding
- By improving the components of the computer for the performance gain, can be calculated using
- The largest form of the clusters are called
- Different types of parallelism in the applications like:
- Benchmarks remain indefinitely valid, the given statement is referred to as
- Single instruction single data stream (SISD) category is the
- For measuring the ability of a computer system for handling the transactions that is consisted of access of database and updates of benchmark used is
- The term 'computer architecture' is sometimes referred only to
- Thousands of concentric circles, magnetic-disk are made up of are known as
- The general categories of instructions\' operation are
- A wafer is normally tested and is chopped into
- Programs which are tend to reusing data as well as instructions they have used just before, is known as
- Being able for expanding memory, no of processors and the disks is called
- SaaS is known as a growing software as a
- From a reference initial instant, a measure of service accomplishment. is known as
- The cost of the die can be calculated as
- Fake programs that are made to try to compare the profile and behavior of original applications, such as Dhrystone are called as
- Data-level parallelism/task-level parallelism in a tightly coupled hardware which allows interaction among parallel threads, are processed by
- The no of dies/wafer is approximately the area of wafer which is divided by the area of this die. It is estimated by
- In switching transistors the traditional primary energy-consumption, also called
- Power is energy/unit time: 1 watt =
- Desktop benchmarks; which are divided into a
- MISD data stream is the abbreviation of
- A time between the start and accomplishment of an event, is called a
- A 2nd key feature of server systems is
- Reporting performance measurements' guiding principle would be
- If floating-point instructions are not being executed, then the floating-point unit will have a clock of
- Processor A having 20% higher power-consumption than the processor B, but if processorA executes task in only 70% of average time needed by B, then its energy consumption will be
- Products being sold by multiple vendors in very large number are called
- The response time matters in the commercial market, uses like:
- Transistor density increasing by 35%/year, quadrupling over the 4years, the given technology is known as
- In floating point instruction format the Opcode contains
- Size of computer accumulator register can be of
- Computer component which is fastest is
- In computer, size of DI, SI, SP and BP stack control register is
- Register used as a working area in CPU is
- Fetch operation are not required in
- Example of implied addressing is
- Which of the following is not a kind of register?
- In an instruction, address part points to the address of the actual data, than the address mode is
- Addressing mode used in the instruction PUSH B, is
- Immediate addressing mode of instruction provides the operand in the memory location to
- Addressing mode used in an instruction of the form ADD X, Y, is
- Which of the following is not the type of computer register?
- Component used to store one or more bit of data and can accept and/or transfer information serially is called
- Computer register which collects the result of computation is called
- Temporary storage area within CPU is called
- In register addressing mode operands are looked in
- Computer register which is used to keep track of address of the memory location where the next instruction is located is
- In the indirect address mode,
Computer
(c).a medium speed converter
need an explanation for this answer? contact us directly to get an explanation for this answer